Expert Dodge Repair & Service Workshop in Abu Dhabi

Dodge Engine Work

Certified technicians diagnose and repair the 3.6L Pentastar V6 and the 5.7L and 6.4L HEMI V8 engines used across the Charger, Challenger, and Durango lineup. Common repairs include lifter and camshaft replacement on the Pentastar V6 and exhaust manifold bolt service on HEMI V8 units.

Abu Dhabi's summer ambient temperatures above 45°C accelerate coolant breakdown in HEMI engines, so the workshop tests coolant condition at every engine visit rather than relying on mileage intervals alone.

Dodge Transmission Work

The ZF 8HP70 8-speed automatic transmission fitted to the Dodge Charger and Challenger receives fluid analysis, valve body diagnostics, and torque converter service at this workshop. Technicians use wiTECH 2.0 to read adaptive shift data before recommending a repair path.

Fluid in this transmission oxidizes faster under Abu Dhabi's sustained highway heat between May and September, which shortens the interval before a fluid and filter change is required compared to cooler climates.

Dodge Suspension Repair

Struts, control arm bushings, and the multi-link rear suspension on the Charger and Durango are inspected and replaced at this workshop. Worn bushings produce a distinct clunk over speed bumps that technicians isolate using a road test and a lift inspection.

Rubber suspension bushings degrade faster in Abu Dhabi's heat, and rough surfaces on roads such as the Mussafah industrial routes add mechanical stress that shortens bushing lifespan further.

Dodge Brake Pad & Brake System Service

Brake pad, rotor, and caliper service is available for Brembo-equipped SRT models and standard Charger and Durango trims. The workshop matches pad compound to the vehicle's factory brake package to preserve pedal feel.

Coastal humidity in Abu Dhabi promotes rotor surface corrosion on vehicles parked outdoors for extended periods, which technicians check for during every brake inspection.

Dodge AC Repair

AC compressor, condenser, and refrigerant charge service addresses cooling performance loss in Dodge vehicles operating in Abu Dhabi's climate. Technicians pressure-test the system and inspect the compressor clutch before recharging refrigerant.

Ambient temperatures exceeding 48°C in July and August place continuous load on the AC compressor, which increases compressor clutch wear compared to markets with shorter summer seasons.

Dodge Electrical & PCM Diagnostics

Electrical faults, including PCM communication errors and sensor failures, are diagnosed using the Chrysler wiTECH 2.0 platform connected through the vehicle's OBD-II port. Technicians pull live data and stored fault codes before recommending a repair.

Extended heat exposure inside a parked Dodge in Abu Dhabi accelerates connector and wiring insulation degradation, a factor technicians check first when a customer reports an intermittent electrical fault.

Dodge Cooling System Repair

Radiator, water pump, and thermostat replacement keeps the Pentastar V6 and HEMI V8 engines within normal operating temperature. Technicians pressure-test the cooling system to locate leaks before component replacement.

A Dodge cooling system under-performs faster in Abu Dhabi than in temperate markets, since ambient air temperature reduces the radiator's heat rejection capacity during peak summer hours.

Dodge Wheel Alignment

Four-wheel alignment corrects tyre wear patterns caused by suspension component wear or impact damage. The workshop uses a computerized alignment rig calibrated to Dodge factory camber and toe specifications.

Potholes and speed bump impacts on Mussafah industrial roads are a frequent cause of alignment drift on Dodge vehicles serviced at this workshop.

Dodge Exhaust System Repair

Exhaust manifold, catalytic converter, and muffler repair addresses exhaust leaks and emissions faults on HEMI V8 and Pentastar V6 models. Technicians inspect manifold bolts first, since HEMI exhaust manifolds are a documented leak point.

High under-hood temperatures in Abu Dhabi accelerate exhaust manifold bolt loosening on HEMI-equipped Dodge vehicles, producing a ticking noise at cold start that technicians treat as a diagnostic starting point.

Dodge Body Work

Structural and panel repair covers collision damage to the Charger's LD platform and the Challenger and Durango's LA and WD platforms. Technicians assess frame alignment before proceeding with panel replacement.

Sand and grit exposure on Abu Dhabi roads accelerates paint chip formation on lower body panels, which technicians flag during body work as a corrosion risk if left untreated.

Dodge Paint

Colour-matched refinishing covers factory Dodge paint codes, including TorRed, Hellraisin, and Pitch Black. The workshop blends panels to match factory clear coat gloss levels before final polish.

UV exposure at Abu Dhabi's latitude fades paint faster than in temperate climates, making factory colour-code matching more difficult on vehicles older than five years.

Dodge Dent Repair

Paintless dent removal addresses minor door and panel dents without disturbing factory paint, while conventional dent repair covers deeper damage requiring filler and refinishing. Technicians select the method based on dent depth and panel access.